BEC MX-230 M1 User Manual page 57

Failover/Fallback Rule Decisions:
1. Probe by Ping: Enable Ping to the gateway or an IP address
 Gateway: Internal system will wait for responses to the pings from the gateway of the WAN.
 Host: Internal system will wait for responses to the pings from a fixed IP address.
2. Probe by Signal Strength: Enable to measure the LTE signal strength
 Minimum RSRP / RSSI: Set a minimum requirement for RSRP and RSSI for initiating
automatic WAN failback or failover procedures.
The valid range is from -111 ~ -5. 0 means don't care/no need to check this value.
NOTE: Both the RSRP and RSSI cannot be 0 at the same time.
Click Save to apply settings.
BEC MX-230 M1 User Manual
Dual WAN – General Setting (Failover & Failback)
Device Configuration
52