Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BEC MX-221P
Summary of Contents for BEC MX-221P
- Page 1 BEC MX-221P Triple-SIM 4G/LTE Router Quick Start Guide...
- Page 3 INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE ONLINE USER MANUAL. Package Contents ✓ BEC MX-221P 4G/LTE Router * 1 ✓ This Quick Start Guide * 1 ✓ RJ-45 Ethernet Cable * 1 ✓...
-
Page 4: Front Panel Leds
MX-221P is either in debug mode or in upgrading firmware process Orange Green IP address has received, and traffic is passing thru the device IP address request has failed Internet MX-221P is either in bridged mode or WAN connection is not ready... -
Page 5: Rear Panel Connectors
SIM Card Slots SIM 3 : Insert the mini SIM card (2FF) with the gold contact facing down Push the mini SIM card (2FF) inwards to eject it * Power off the MX-221P before inserting or removing the SIM card(s) -
Page 6: Application Diagrams
Quick Start Guide Application Diagrams WAN: 4G/LTE | Power Source: DC Power (ON) | LAN: Ethernet Devices II. WAN: 4G/LTE | Power Source: PoE Injector (OFF). LAN1: Connect to the PoE injector | LAN2: Ethernet Device (notebook, switch, etc.) III. WAN: Ethernet WAN (LAN2) | Power Source: DC Power Adapter (ON). LAN1: Ethernet Device (notebook, switch, etc.) | LAN2: Wireline Modem... -
Page 7: Hardware Installation
Select power source from using a (1) DC power adapter or (2) PoE Injector 1.1 Using the Supplied DC Power Adapter Plug in the supplied power adapter to the wall jack, the other side to the MX-221P then power it ON the by pressing the Power On/Off button. - Page 8 Plug the RJ-45 Ethernet cable to one of the Ethernet ports, and the other side to the PC’s Ethernet interface. 3. WAN Link Interface and Connection BEC MX-221P supports failover and failback to another WAN interface, 4G/LTE or Ethernet WAN. <Please refer to user manual for detailed setup> 3.1 Mobile 4G/LTE Connection Slide SIM card(s) into SIM tray starting with (default) SIM1 / SIM2 / SIM3.
- Page 9 BEC MX-221P Triple-SIM 4G/LTE Router 3.2 Ethernet WAN Connection Connect RJ-45 Ethernet cable to the WAN port and connect the other side to another alternative broadband device, such as Cable Modem, VDSL, Fiber Modem, or PON optic line.
- Page 10 Quick Setup Your Router Use the Quick Start for fast connection setup. Wired Broadband Connection - before start configuring the MX-221P, make sure you have the LAN2/WAN connect to your Internet box or fiber line. Step 1: Change administration password Setup a new password for “admin”...
- Page 11 BEC MX-221P Triple-SIM 4G/LTE Router Step 3: WAN / Internet Connection Setup Select the appropriate WAN protocol then fill out the information provided by your ISP in all relevant parameters. (4G/LTE) If select 4G/LTE to connect to the internet WAN Interface: select...
-
Page 12: Troubleshooting
Quick Start Guide Troubleshooting 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem. In this case you should contact technical support. 2.