Recovery Procedures - BEC MX-230 M1 User Manual

Recovery Procedures

Problem
1. The front LEDs display incorrectly
upgrade
2. Still cannot access to the router
management interface after pressing
the RESET button.
3. Software / Firmware upgrade failure
BEC MX-230 M1 User Manual
Suggested Action
Before starting recovery process, please configure
the IP address of the PC as 192.168.1.100 and
proceed with the following step-by-step guide.
1. Power the router off.
2. Press reset button and power on the router, once
the Power lights Red, keeping press reset button
over 6 seconds.
3. Internet LED flashes Green, router entering
recovery procedure and router's IP will reset to
Emergency IP address (Say 192.168.1.1).
4. Open browser and access http://192.168.1.1 to
upload the firmware.
5. Internet LED lit Red, and router starts to write
firmware into flash. Please DO NOT power off the
router at this step.
6. Internet LED lit Green when successfully upgrade
firmware.
7. Power cycle off/on the MX-230 M1
Troubleshooting 103