Yealink SIP-T42S User Manual page 36

User Guide for the SIP-T42S IP Phone
wireless network.
Personal Identification Number (PIN)
To connect to the wireless network using PIN method:
Press Menu->Settings->Basic Settings->Wi-Fi.
1.
Press the WPS soft key, and then select WPS-PIN.
2.
The LCD screen prompts "Please input below PIN code on your Wi-Fi router and press OK
to connect: xxx".
Log into your gateway/router's web interface, and configure it to search the clients. For
3.
more information, refer to the documentation from the gateway/router manufacturer.
Once WPS-PIN setup has completed successfully, the gateway/router's web interface will
prompt success.
Note
Contact your gateway/router provider for more information.
Manually Add a Wireless Network
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results.
In that case, you must manually add a wireless network.
To add a wireless network:
Press Menu->Settings->Basic Settings->Wi-Fi.
1.
Press
2.
Use the WLAN settings obtained from your gateway/router to configure this WLAN Profile
3.
on the IP phone. Do the following:
If you select None or WEP from the pull-down list of Security Mode:
a)
Enter the profile name, SSID and WPA shared key in the corresponding fields.
If you select WPA-PSK or WPA2-PSK from the pull-down list of Security Mode:
b)
Select the desired Cipher type (TKIP, AES or TKIP AES) from the pull-down list of
Cipher Type.
Enter the profile name, SSID and WPA shared key in the corresponding fields.
Press the Save soft key to accept the change or the Back soft key to cancel.
4.
The connected wireless networks will be saved to Known Network(s) list. The Known
Network(s) list can store up to 5 wireless networks, you can specify the priority to connect to
the corresponding wireless network.
26
or to highlight Known Network(s), and then press the Add soft key.