Installation and Setup
Table 2-1
9433-EMDE-75/110 Rear I/O Modules — continued
9433-EMDE-75/110 Rear I/O Module
RM20-9433EMDE-B
Fiber and Balanced Audio Connections
9433EMDE-75-110-OM (V1.6)
Figure 2-2 shows connections to the card multi-pin terminal block connectors.
These connectors are used for card balanced audio connections. Figure 2-2
also shows how to install the blindmate fiber adapter to the rear module.
Note:
It is preferable to wire connections to plugs oriented as shown in
Figure 2-2 rather than assessing orientation on rear module connectors. Note
that the orientation of rear module multi-pin audio connectors is not
necessarily consistent within a rear module, or between different rear
modules. If wiring is first connected to plug oriented as shown here, the
electrical orientation will be correct regardless of rear module connector
orientation.
9433-EMDE-75/110 PRODUCT MANUAL
Fiber and Balanced Audio Connections
Description
Provides the following connections:
• One 3G/HD/SD-SDI coaxial input BNC (SDI IN)
• One 3G/HD/SD-SDI fiber LC input (FIBER IN)
• Eight AES/EBU balanced audio input/outputs
(BAL AES AUD I/O 1 thru AES AUD I/O 8)
• Two AES-3id unbalanced audio input/outputs via
HD-15 connector (per illustration)
• One 3G/HD/SD-SDI coaxial output BNC (SDI OUT)
• One 3G/HD/SD-SDI fiber LC output (FIBER OUT)
2-5