Related Manuals for Cobalt Digital Inc 9061
Summary of Contents for Cobalt Digital Inc 9061
- Page 1 Cobalt Digital Inc. 9061 Up/Down/Cross Format Converter, Video/Audio In with Frame Sync Owner’s Manual 9061-OM Version: 1.0.9...
- Page 2 The material in this manual is furnished for informational use only. It is subject to change without notice and should not be construed as a commitment by Cobalt Digital Inc. Cobalt Digital Inc assumes no responsibility or liability for errors or inaccuracies that may appear in this manual.
-
Page 3: Important Safety Instructions
To reduce the risk of fire, replacement fuses must be the same type and rating. Only use attachments/accessories specified by the manufacturer. 9061 Owner’s Manual • • • • (V 1.0.9) Page 3 of 28... - Page 4 If you need more information on the collection, reuse, and recycling systems, please contact your local or regional waste administration. You can also contact Cobalt Digital for more information on the environmental performances of our products. 9061 Owner’s Manual • • • • (V 1.0.9) Page 4 of 28...
-
Page 5: Table Of Contents
Troubleshooting Checklist .......................24 Warranty and Repair Policy .....................25 Ordering Information 9061 and Related Products.......................26 Contact Us Contact Cobalt Digital Inc......................28 Visit us at the Cobalt Digital Inc. website................28 9061 Owner’s Manual • • • • (V 1.0.9) Page 5 of 28... -
Page 6: Introduction
The 9061 can best be thought of as a universal input processing card with audio and video support. The video source can be either the HD/SD-SDI input or the HD/SD analog video input. The video can be up, down, or cross converted to a different format, and aspect ratio corrected to provide proper output aspect. - Page 7 The 9061 features a scaler card which provides the up, down, and cross conversion using de-interlacing and motion adaptation for high quality up conversions. The scaler also provides user adjustable aspect ratio control and zoom control. Separate controls are provided for SD and HD inputs to allow the card to flexible handle mixed input formats.
-
Page 8: Functional Block Diagram
Not supported as analog video input formats Embedded Audio The 9061 supports all four groups (16 channels) of embedded audio at full 24 bit resolution in both SD (with extended data packets) and HD. 9061 Owner’s Manual • • • • (V 1.0.9) -
Page 9: Analog Audio
AES input at 32 kHz, 44.1 kHz, 96 kHz or 192 kHz rates. Discrete AES Audio Output The 9061 can emit 16 channels (8 pairs) of discrete AES audio on 75 ohm BNC connections. The AES clock rate will be precisely locked to the output video rate. -
Page 10: Installation And Setup
Unpack each card you received from the shipping container, and check the contents against the packing list to ensure that all items are included. If any items are missing or damaged, contact your sales representative or Cobalt Digital directly. 9061 Owner’s Manual • • • • (V 1.0.9) Page 10 of 28... -
Page 11: Rear Module Installation (Optional)
Using a Phillips driver and the supplied screw, fasten the 8310-RM-10 panel to the 8310 back plane. Do not over tighten. This completes the procedure for installing the 8310-RM-10 in an 8310 openGear frame. 9061 Owner’s Manual • • • • (V 1.0.9) Page 11 of 28... -
Page 12: Board Installation
AES IN/OUT 2 AES IN/OUT 4 AES IN/OUT 3 HD/SD SDI HD/SD SDI Output 1 Output 2 Figure 3. BNC Designations for the Card Rear Module RM-9061-A or 8310-RM-100 9061 Owner’s Manual • • • • (V 1.0.9) Page 12 of 28... -
Page 13: Card Control And Status
0 no change is made. If set to 1024 absolute black (value 004) becomes absolute white (value 3FB). If set to –1024, absolute white becomes absolute black. 9061 Owner’s Manual • • • • (V 1.0.9) Page 13 of 28... - Page 14 Allows the user to specify an additional vertical offset between the output video and the frame sync reference in lines. These are lines in the reference format, not the output video format. 9061 Owner’s Manual • • • • (V 1.0.9) Page 14 of 28...
-
Page 15: Audio Delay
Displays the format and rate of the input video signal. Output Format Selected This is the format output from the SDI BNCs after the scaler setup rules are applied. 9061 Owner’s Manual • • • • (V 1.0.9) Page 15 of 28... - Page 16 Output Polarity Grp4 Enbl Embedded Group Enable Ch13- Output Source Ch16 Gain Output Gain (x4) Output Polarity Ch01- Output Source Ch16 Gain Output Gain (x16) Output Polarity 9061 Owner’s Manual • • • • (V 1.0.9) Page 16 of 28...
- Page 17 In this parameter, move the toggle switch up to save the settings to the card persistent storage. Load Settings In this parameter, move the toggle switch up to load the saved settings and make them active. 9061 Owner’s Manual • • • • (V 1.0.9) Page 17 of 28...
-
Page 18: Factory Default Settings
5) The Scaler is enabled and both SD and HD are set to be the same as input and half rate 720p is turned off. 6) Aspect ratio is set to 1.0HV (No Correction) 9061 Owner’s Manual • • • • (V 1.0.9) Page 18 of 28... -
Page 19: Remote Control
Detected Video Standard ############ Standard on SDI or Analog Input Detected standard of Reference Standard ############ selected reference. Displays the Silicon Serial ############ Number of the card. 9061 Owner’s Manual • • • • (V 1.0.9) Page 19 of 28... - Page 20 Gain applied to embedded Gain Range (-400) – 400 audio output, one slider (per channel) for each channel. Inverts the phase of the Normal Phase embedded audio. (per channel) Invert 9061 Owner’s Manual • • • • (V 1.0.9) Page 20 of 28...
- Page 21 YPbPr Specifies the amount of SD Composite setup (pedestal) in the 0.0 or 7.5 IRE of Setup Contains input video. It will be removed by the decoder. 9061 Owner’s Manual • • • • (V 1.0.9) Page 21 of 28...
- Page 22 SD, 720p, 1080I, or SD: Convert to when an SD input is 1080p detected Outputs 720p at half rate SD: Output half- (720p25, 30, or 29.97). rate 720p 9061 Owner’s Manual • • • • (V 1.0.9) Page 22 of 28...
- Page 23 (Horizontal) to double original size. HD: User-defined Selects the amount of aspect ratio Range (0.5 – 2.0) vertical zoom from half (Vertical) to double original size. 9061 Owner’s Manual • • • • (V 1.0.9) Page 23 of 28...
-
Page 24: Service Information
Module Exchange Exchanging a suspect module with a module that is known to be working correctly is an efficient method for localizing problems to individual modules. 9061 Owner’s Manual • • • • (V 1.0.9) Page 24 of 28... -
Page 25: Warranty And Repair Policy
FIVE (5) years from the date of shipment from our factory. In the event that your Cobalt Digital Inc. card proves to be defective in any way during this warranty period, Cobalt Digital Inc. reserves the right to repair or replace this piece of equipment with a unit of equal or superior performance characteristics. -
Page 26: Ordering Information
Ordering Information 9061 and Related Products Your 9061 HD/SD Up/Down/Cross Format Converter, Video/Audio In with Frame is a part of the openGear family of products. Cobalt Digital offers a full line of openGear terminal equipment including distribution, conversion, monitoring, synchronizers, encoders, decoders, embedders, and de- embedders, as well as analog audio and video products. - Page 27 Notes: 9061 Owner’s Manual • • • • (V 1.0.9) Page 27 of 28...
-
Page 28: Contact Us
Visit us at the Cobalt Digital Inc. website. http://www.cobaltdigital.com • Online catalog • Related products and full product lines • Trade show information • Dealer information • Cobalt Digital Inc. news 9061 Owner’s Manual • • • • (V 1.0.9) Page 28 of 28...