Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode - Directed SmartStart ASRF-3510 User Manual

Active Mode:
To arm the Starter Kill:

Press the

The parking lights will flash once.

The LED on the antenna will flash slowly.

If remote door locks are installed, this will also lock the doors and arm
the OEM-style alarm (if configured).
To disarm the Starter Kill:

Press the

The parking lights will flash twice.

The LED on the antenna will remain OFF.

If remote door locks are installed, this will also unlock the doors and
disarm the OEM-style alarm (if configured).

Remote-Starting Your Vehicle

Setting Your Vehicle into Ready Mode

If your vehicle has a manual transmission you must read the following
indications. In order to start the vehicle by remote, the unit must first be set to
Ready Mode. If the unit is not set to Ready Mode, it cannot remote start the
vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake,
depending on the option that was selected by your installer. Therefore, you must
follow the appropriate procedure between the two described below in order to set
your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and
stopped at any time. The system will exit Ready Mode if a door, the hood or the
trunk is opened, if the brake pedal is pressed, if the parking brake is disengaged
or if the ignition key is turned to the IGNITION ON (RUN) position.
User Guide
button on the transmitter.
button on the transmitter.
P.9