Engine Run Time; Turbo Mode - Directed SmartStart ASRF-3510 User Manual

Swap start (2-way remote): If this feature is enabled;
1. Press and release the AUX button.
2. The
3. While it is lit, press
4. The AUX 2 output can be activated by pressing the
Swap start (1-way remote): If this feature is enabled;
Rapidly press AUX twice. The remote's LED will start flashing.
1.
2. While the LED is flashing, press
3. The

Engine Run Time

If you have a gas engine, your Remote Car Starter can be programmed to run
the engine for 3, 15, or 25 minutes (15 minutes by default). If you have a diesel
engine, the Remote Car Starter can be programmed to run the engine for 8, 20,
or 30 minutes (20 minutes default).

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down
after the user leaves the vehicle: the unit will take over the vehicle and keep it
running for 60 seconds (or until it is shut down by remote control), then shut
down the engine.
If your vehicle has an automatic transmission, proceed as follows to set the
system to Turbo Mode:
1. With the engine running, make sure to release the brake pedal and
press the
lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to
2.
activate Turbo mode.
3. Remove the ignition key from the ignition switch. The engine will
continue running.
4. Exit the vehicle and close all doors, hood and trunk.
P.20
button on the transmitter will light up.
AUX 2
output can be activated by pressing the
, or
to remote start the car.
to remote start the car.
button on the transmitter until the parking
button.
button.
User Guide