Remote-Starting Your Vehicle; Setting Your Vehicle In To Ready Mode - Directed Smart Start ASRF-1510 User Manual

Remote-Starting Your Vehicle

Setting Your Vehicle in to Ready Mode

If your vehicle has a manual transmission you must read the following
indications. The unit must first be set to Ready Mode in order to start the vehicle
by remote. If the unit is not set to Ready Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake,
depending on the option that was selected by your installer. Therefore, you must
follow the appropriate procedure between the two described below in order to set
your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and
stopped at any time. The system will exit Ready Mode if a door, the hood or the
trunk is opened, if the brake pedal is pressed, if the parking brake is disengaged
or if the ignition key is turned to the IGNITION ON (RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear
selector is in the neutral position.
2. With the engine running, apply the
parking brake once and release the
brake pedal.
3. Within 20 sec. of engaging the
parking brake, press and hold
or on the transmitter
(SmartStart™ uses only the
SmartStart™ icon).
The parking lights will flash 3 times
quickly and remain lit. Release the
button.
Remove the key: the engine will keep on running.
4.
User Guide
If Ready Mode is enabled by
handbrake
2. With the engine running, apply the
parking brake twice within 10 sec.
3. Make sure to release the brake
pedal.
The parking lights will flash 3 times
,
quickly and remain lit.
P.9