Differential Assembly (3Rd Member); Disassemble - Taylor-Dunn SC-001-59 Operation, T Roubleshooting And Replacement Parts Manual

Transmission
DIFFERENTIAL ASSEMBLY (3

Disassemble

NOTE: Bearings and races must be replaced as a set. If any one bearing
1. Drain the oil from the differential housing and chain case. Refer to section
information regarding draining the oil.
2. Remove the transmission assembly from the vehicle. Refer to
Remove and Install
3. Remove both rear axle assemblies. Refer to section
information regarding removing the axles.
4. Remove the chain case and backing plate from the 3rd member. Refer to section
Disassemble
5. Remove the nuts holding the 3rd member to the axle housing and remove the 3rd member from
the housing.
6. Install a spacer on the pinion shaft so that the pinion nut can be installed and tightened.
7. While rotating the pinion shaft, tighten the pinion
nut to 100 ft-lbs.
8. Measure and record the ring and pinion gear
backlash. This setting will be used during
reassembly.
9. Remove the pinion housing and pinion gear from
the 3rd member.
NOTE: Do not lose the spacers and shims in the pinion housing or the
or race is worn, its mate must also be replaced. It is recommended
to replace all bearings and races in the 3rd member as a set.
for information regarding removing the transmission.
for information regarding removing the chain case.
pinion housing shim(s).
Transmission
RD
MEMBER)
Rear Axle: Remove and Install
Page 14
Change the Oil
Transmission Assembly:
Chain Case:
for
for