Full Quick Auto Setup And Quick Auto Setup; Auto White Balance - Ikegami HDK-97C Operation Manual

4.6 Auto Setup

FULL QUICK Auto Setup and QUICK Auto Setup

To activate the FULL QUICK auto setup or QUICK auto setup from the camera, select "F.QUICK" or "QUICK" from the camera
menu "AUTO SETUP MODE" - "AUTO SETUP". To perform the FULL QUICK/QUICK auto setup from an OCP or MCP,
perform the following steps.
1
Press the SETUP button in the function switch part.
2
Press the AUTO SETUP button on the LCD.
3
Press the Full Quick or Quick button on the LCD.
4
Press the Start button on the LCD.

Auto White Balance

Auto white balance can be activated from the camera, OCP, or MCP. This section explains how to activate from the camera.
1
Use the AWB SELECT switch to select the
memory (Ach or Bch) in which to store the
execution result.
AWB settings can be stored in two memories. Use
them selectively depending on different conditions.
A : Ach memory
B : Bch memory
OFF : White balance adjustment is in the preset
condition (3200K). AWB cannot be activated
when the switch is set to this position.
Note:
The data previously stored in the memory is
overwritten. Also, when the camera is connected to
the CCU or remote controller, the AWB SELECT
switch is disabled.
2
Use the CC FILTER switch and ND FILTER switch on the right side of the camera to set the optical filter which
suits the light source.
If the operational priority for the filter is not given to the camera, press the FILTER HEAD switch to switch the
operational priority to the camera. When the priority is given to the camera, an asterisk (*) is displayed in the viewfinder.
3
Shoot a subject which contains something white.
Make sure that the white subject fills at least 10% of the screen.
68
HDK-97C 1303 VER1 (U)
①
Use the AWB SELECT switch
to select the memory.