Switch Position Check - Ikegami HDK-97C Operation Manual

4.2 Switch Position Check

4.2 Switch Po ition Check
When the camera is used for the first time, set the switches on the camera to the positions indicated in the figure below, and ensure
that the camera works properly. After ensuring that it works properly, set the switches according to the environment in which the
camera is used and shooting conditions.
Camera Right
■
- GAIN SELECT switch : 0
- AWB SELECT switch : A
- CC FILTER switch : B (3200K)
- ND FILTER switch : 2 (100%)
- OUTPUT SELECT switch : CAM
- SHUTT/SUP-V switch : OFF
Note:
When the camera is connected to the CCU, the switches on
the camera are disabled except the CC FILTER switch and ND
FILTER switch. When the camera has the operational priority
for the CC FILTER and ND FILTER switches, the FILTER
local indicator lights. Pressing the FILTER HEAD switch will
switch the operational priority between the camera and the
CCU.
■ Camera Front
- P.FUNC switch : OFF
Note:
When the camera is connected to the CCU, you cannot use the
P.FUNC switch.
■ Camera Rear
- INCOM FRONT VR SELECT switch : OFF
- ENG MIC switch
- PROD MIC switch
- MIC-1 POWER switch, MIC-2 POWER switch
Depending on the type of microphone to use, the power supply
settings differ.
Switch Po ition
AB+12V Supplies +12V AB power to the microphone.
OFF Supplies no power to the microphone.
Applicable for a dynamic microphone or
a microphone with built-in power supply
which requires no power supply.
+48V Supplies +48V Phantom power
Reference:
For details on the microphone, refer to the instructions accompanying the microphone to be used.
58
: ON
: ON
De cription
HDK-97C 1303 VER1 (U)
SHUTT/SUP-V switch
GAIN SELECT switch
OUTPUT SELECT switch
AWB SELECT switch
P.FUNC switch
ENG MIC
switch
MIC-1 POWER
switch
CC FILTER switch
ND FILTER switch
INCOM FRONT VR
SELECT switch
PROD MIC
switch
MIC-2 POWER
switch