Monitor Connection; Connecting Camera And Monitor - Ikegami HDK-97C Operation Manual

3.4 Monitor Connection

This section explains how to connect the HDK-97C to the monitor.

Connecting Camera and Monitor

There are three connectors on the rear of the camera to output various video signals. The type of video signal output from each
connector is different. Be sure to connect to a correct connector via a coaxial cable in accordance with the monitor to be used.
- Q-TV/GL, MON OUT connector : Selection between Q-TV/GL and MON OUT is made by the Q-TV/GL, MON OUT SELECT
- SDI OUT connector
- MON SDI connector
FA-97
Camera rear view
Via 5CFB coaxial cable
with a maximum length of 100m
switch.
If Q-TV/GL is selected, this connector outputs the Q-TV OUT/VBS signal when the camera is
connected to the CCU, or it inputs an external synchronization signal (GENLOCK) when the
camera is used stand-alone.
When MON is selected, this becomes the monitor output of the camera images, and the same
image signals are output as the viewfinder.
: Outputs the digital serial video signal. Applicable to the HDTV SDI signal (not applicable to
the SDTV SDI signal).
: Outputs the digital serial video signal. Applicable to the HDTV SDI signal (not applicable to
the SDTV SDI signal).
Q-TV/GL
MON SDI
AB+12V
+48V
MIC-1 MIC-2
MON SDI connector
MON OUT
connector
HD SDI OUT
connector
VIDEO IN
connector
75 termination
Ω
Coaxial cable
HDK-97C 1303 VER1 (U)
I/O
EARPHONE
SDI OUT
DC OUT
REM
75 Ω termination
OFF
DC IN
Coaxial cable
VIDEO IN connector
SDI-capable
HD color monitor
VIDEO IN
connector
HD B/W monitor
3.4 Monitor Connection
SDI-capable HD
color monitor
51
3