Turning On Power; Power Supply From Power; Power Supply From Ccu - Ikegami HDK-97C Operation Manual

4.3 Turning ON Power

4.3 Turning ON Power
The procedure for turning the power ON/OFF depends on how power is supplied to the camera. This section explains how to
supply power from the POWER (External power) and the CCU.

Power Supply from POWER

Before turning the camera ON, make sure that the POWER switch on the POWER is ON and the POWER indicator lights.
Reference:
Refer to "3. INSTALLATION and CONNECTION", "Power Supply from POWER" (page 47) for how to connect the camera to the AC
pack and how to turn the power ON.
1
Set the POWER switch on the camera to EXT.
Power will be supplied to the camera, and the POWER indicator will light in green.

Power Supply from CCU

Before turning the camera ON, set the switches to the following positions in normal operations. The power is turned ON/OFF by
the MAIN POWER switch on the CCU.
Camera POWER switch
CCU MAIN POWER switch
CCU
HEAD POWER switch
OCP(*) CAM POWER switch
(*) When OCP-200 is used, the setting for the CAM POWER switch is not necessary.
1
Turn ON the MAIN POWER switch on the CCU.
The CCU checks the fiber cable connection and supplies power to the camera if the cable is properly connected. The
CABLE indicator on the CCU will indicate the connection status of the fiber cable.
NORMAL (green)
OPEN (red)
SHORT (red)
60
Switch
: Lights when the fiber cable is normally connected. The CCU checks the camera code transmitted
from the camera to confirm that the camera is an applicable model, and then supplies power to
the camera.
: Lights when the fiber cable is not connected or there is an "open" in the fiber cable.
: Lights when a short circuit occurs in the fiber cable due to a cause such as water.
HDK-97C 1303 VER1 (U)
Switch Po ition
BS/CCU
OFF
I
ON