Alarm Lamp On The Ocp Or Mcp Flashes On And Off - Ikegami HDK-97C Operation Manual

Refer to this chapter when the alarm lamp lights or when you want to know about the maintenance during the use of this product.
Problems
■
- The alarm lamp on the OCP or on the MCP flashes ON and OFF.
- "TEMP!!" or "FAN!!" appears on the viewfinder screen.
Questions
■
- How to reset the settings to default (Return to the factory settings)
Maintenance
■
- Cleaning the camera connectors
- Resetting the breaker
6.1 Alarm Lamp on the OCP or MCP Fla he ON and OFF
The CCU is equipped with a self diagnostic function which monitors whether the CCU and camera are running normal. As soon as
the CCU main power switch is turned ON, the self diagnostic function starts running, and always runs during operation.
If the CCU or camera becomes abnormal, the diagnostic function immediately detects the abnormality, and the ALARM indicator
on the OCP or MCP flashes ON and OFF. Furthermore, the self diagnostic information screen appears on the PM, so that you can
locate the trouble point.
Note:
Even if the ALARM indicator does not flash, you can check whether CCU and camera are running normal by pressing the PM IND/
PAGE button on the OCP or on the MCP to display the self diagnostic screen on the PM.
OCP
O C P - 2 0 0
CAM PWR VF PWR
OFF
STANDARD CAP BARS CAL
TALLY
INFO OPE SETUP MAINTE
I O S M
LENS EXT
FULL RELATIVE
KNOB
FREE
HEAD POWER
RANGE SENS
OPT
HEAD CCU
CLS OPEN ±1 ±2
CABLE
OPEN SHORT
ALARM CALL PREVIEW
For the list of self diagnostic information of CCU, refer to the relevant operation manual. Perform the appropriate action referring
to the list.

6.1 Alarm Lamp on the OCP or MCP Flashes ON and OFF

PM IND PANEL
/ PAGE ENABLE
PM IND/PAGE
AWB ABB
button
AWB ABB
USER WFM/PM
U W
IRIS
ALARM
PED
indicator
HDK-97C 1303 VER1 (U)
MCP
MIX
R G B Y SEQ
SUP
6
105