Table of Contents
Advertisement
Menu Configuration and content
The following lists the camera menu configuration.
■
MENU (Simple Menu)
The simple menu is the same as MENU (1/3) described below. Refer to items in MENU (1/3) for details of each menu.
MENU (1/3)
■
Menu Item
VF DISPLAY
DISPLAY MODE
VF DTL
MARKER/CHAR LVL
FRAME MARKER
VF ASPECT
SIDE MASK
CONTRAST
BRIGHT
SAFETY AREA
SAFETY MARKER
CENTER MARKER
FOCUS INDICATE
ZOOM INDICATE
AUTO VF ASPECT
ZEBRA INDICATOR
ZEBRA1 DETECT
ZEBRA2 IND
ZEBRA2 DETECT
ZEBRA IND LVL
*1 : It is possible to determine when loading MENU DATA from the SD CARD whether to read the entire MENU or to read only items related to VF.
The setting of an item having a checkmark is read.
Initial
Setting value
etting
2
OFF, 1, 2
35
1 to 100
100
1 to 100
ON-16:9, ON-14:9, ON-13:9,
OFF
ON-4:3, OFF
16:9
16:9, 4:3
OFF, ON-4:3,
OFF
ON-13:9, ON-16:9
50
0 to 100
60
0 to 100
ACTION
ACTION, TITLE
ON-16:9
ON-4:3, ON-16:9, OFF
ON
ON, OFF
ON
OFF, ON
ON
OFF, ON
OFF
ON, OFF
100%
30 to 109%
OFF
OFF, ON
70%
30 to 109%
78
HDK-97C 1303 VER1 (U)
5.2 Settings from the Menu
De cription, Remark
OFF : The markers and characters are constantly OFF, and
only the warning messages are displayed.
1 : Only the markers are constantly displayed. Information
related to characters is displayed for 2 seconds during
function operation and when changing parameters.
2 : The markers and characters are displayed at all times.
Sets the VF detail amount. The detail amount decreases in the
direction of "0" and increases in the direction of "100".
Sets the brightness levels of the markers and characters. The
brightness level gets dark in the direction of "1".
Sets the frame marker.
Sets the VF aspect ratio.
Sets the side mask.
Adjusts the side mask contrast level.
Adjusts the side mask brightness level.
ACTION ： Area marker of 93% of the screen height and width.
TITLE ： Area marker of 89% of the screen height and width.
Sets the safety marker.
Sets the center marker.
Only active when using the serial lens.
Only active when using the serial lens.
Switches the VF aspect ratio in linked motion with the output
mode of the BS/CCU down converter.
Overlaps the striped pattern signal on the image if the image
level has exceeded the individual DETECT LEVELS.
The zebra indicator goes ON/OFF with the VF special switch.
-Zebra 1 signal ： Fine, slanted striped pattern signal flowing
toward the upper right of the screen.
Use to control the tone of the entire screen.
-Zebra 2 signal ： Thick, slanted striped pattern signal flowing
to the lower right of the screen.
Used for controlling the tone of the subject,
such as face tone, etc
Sets the DETECT LEVEL of the 1st zebra indicator.
Selects whether there is a 2nd zebra indicator or not.
Sets the DETECT LEVEL of the 2nd zebra indicator.
Adjusts the overlap level of the zebra indicator.
*1
MENU DATA
ALL
VF
5
85
Advertisement
Table of Contents
