Use The Http Interface To Find The Firmware Information; Use The Serial Interface To Find The Firmware Information - Comtech EF Data UT-4500 Series Installation And Operation Manual

UT-4500 Series C- and Ku-Band Up Converters
Firmware Update

5.2.3.2 Use the HTTP Interface to Find the Firmware Information

Chapter 7. ETHERNET INTERFACE OPERATION
Do these steps:
1. Go to either of these pages to review the firmware information:
• The 'Firmware Information' section of the 'Config | Utility' page
provides the firmware details as Boot, Bulk1, and Bulk2, as shown
in this example:
• The 'Summary' section of the 'Status | Summary' page provides
the firmware details – "FW Revision", "Active Software Image",
and "Next Reboot Image" – as shown in this example:
2. Write down your firmware information for further reference or to provide
to Comtech EF Data Product support.

5.2.3.3 Use the Serial Interface to Find the Firmware Information

Chapter 8. SERIAL INTERFACE OPERATION
Use your terminal emulator program to execute remote queries with the
UT-4500. Use the "FRM" remote query to find the firmware information:
• <DEV/FRM_{cr}
(returns the complete information of the firmwares running under Boot,
Bulk1, and Bulk2 in the form FW-AAAAAAA B.B.BB DD/MM/YY,
where:
5–5
MN/UT4500.IOM
Revision 3