Table of Contents
Advertisement
1. Disconnect and remove oil pressure switch. See Engine/Lubrication/SWITCH, Oil Pressure -
Removal.
2. Install Special Tools C-3292A Gauge with 8406 Adaptor. For Special Tool identification, see Engine -
Special Tools.
3. Start engine and record oil pressure. Refer to Oil Pressure in Engine Specifications for the correct
pressure. See Engine - Specifications.
FILTER, ENGINE OIL
Removal
REMOVAL
Fig. 176: 3.8L Oil Pressure Switch
Courtesy of CHRYSLER LLC
CAUTION: When servicing the oil filter avoid deforming the filter can by installing the
remove/install tool band strap against the can-to-base lock seam. The lock
seam joining the can to the base is reinforced by the base plate.
1. Using suitable oil filter wrench, turn filter (2) counterclockwise to remove from oil filter adapter. Properly
discard used oil filter.
Installation
INSTALLATION
viernes, 1 de octubre de 2021 05:18:32 p. m.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
Page 145
© 2011 Mitchell Repair Information Company, LLC.
Advertisement
Table of Contents
