Table of Contents
Advertisement
INSTALLATION
Fig. 144: CRANKSHAFT DAMPER
Courtesy of CHRYSLER LLC
1 - FORCING SCREW/NUT FROM SPECIAL TOOL 8452
2 - VIBRATION DAMPER
3 - THRUST BEARING/WASHER
1. Install crankshaft vibration damper using the forcing screw, nut, and thrust bearing/washer (3) from
Special Tool 8452 (1).
NOTE:
To minimize friction and prolong tool life, lubricate the threads on the
forcing screw of Special Tool 8452.
2. Position vibration damper on crankshaft.
3. Screw Special Tool 8452 (1) into crankshaft until the bolt seats. Turn the nut to install damper until it
seats fully.
4. Remove Special Tool 8452.
5. Install vibration damper bolt. Torque bolt to 54 N.m (40 ft. lbs.).
6. Install the accessory drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Installation .
7. Connect negative cable to battery.
FLEXPLATE
Removal
REMOVAL
viernes, 1 de octubre de 2021 05:18:31 p. m.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
Page 114
© 2011 Mitchell Repair Information Company, LLC.
Advertisement
Table of Contents
