Table of Contents
Advertisement
Fig. 161: CONNECTING ROD TO CYLINDER IDENTIFICATION
Courtesy of CHRYSLER LLC
1 - PAINT MARK OR SCRIBE
NOTE:
Refer to the connecting rod Description before beginning repair. See
Engine/Engine Block/ROD, Piston and Connecting - Description.
1. Disconnect and isolate the negative battery cable.
2. Remove the cylinder heads. See Engine/Cylinder Head - Removal.
3. Remove the oil pan. See Engine/Lubrication/PAN, Oil - Removal.
4. Remove the top ridge of cylinder bores with a reliable ridge reamer, if necessary, before removing pistons
from cylinder block. Be sure to keep tops of pistons covered during this operation. Pistons and
connecting rods must be removed from top of cylinder block. When removing piston and
connecting rod assemblies from the engine, rotate crankshaft so that each connecting rod is
centered in cylinder bore.
5. Inspect connecting rods and connecting rod caps for cylinder identification (1). Identify them if
necessary.
viernes, 1 de octubre de 2021 05:18:31 p. m.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
Page 130
© 2011 Mitchell Repair Information Company, LLC.
Advertisement
Table of Contents
