Engine Mounting - Jeep Wrangler Sport 2010 Manual

2. Position new seal (2) over the guide with the seal spring in the direction of the engine front cover.
3. Install seal using Special Tool C-4992-1 (1) until seal is flush with cover.
4. Install crankshaft damper. See Engine/Engine Block/DAMPER, Vibration - Installation.
5. Install accessory drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Installation .
6. Lower vehicle and connect negative cable to battery.

ENGINE MOUNTING

INSULATOR, ENGINE MOUNT, FRONT
Removal
REMOVAL
1. Disconnect the negative cable from the battery.
2. Remove the engine oil filter.
3. Support the engine with a suitable jack and a block of wood across the full width of the engine oil pan.
4. Remove the cylinder block-to-insulator mount bolts and the nut from the engine insulator mount through
bolt.
5. Using the jack, raise the engine high enough to remove the engine insulator mount thru bolt and the
insulator mount.
Installation
INSTALLATION
1. Position the insulator mount and install the insulator mount through bolt.
2. Lower the engine until the cylinder block-to-insulator mount bolts can be installed.
3. Remove the jack and block of wood.
4. Torque the cylinder block-to-insulator mount bolts to 61 N.m (45 ft. lbs.).
5. Install and torque the through bolt retaining nut to 61 N.m (45 ft. lbs.).
INSULATOR, ENGINE MOUNT, REAR
Removal
REMOVAL
MANUAL TRANSMISSIONS
viernes, 1 de octubre de 2021 05:18:31 p. m.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
Page 139 © 2011 Mitchell Repair Information Company, LLC.