Lauda P 10 Operation Manual page 63

V6
4. Switch on the device.
If the device is empty, filling mode is activated immediately after

the device is switched on.
If the device is not empty, filling mode can be manually started.
Touch the Pump  filling mode  Start filling tile.
5. Remove the tank lid.
A screen is fitted to the filling nozzle. Do not remove the screen!

6. Carefully fill with heat transfer liquid.
A signal tone with long intervals is emitted starting from around

the fifth level to warn against overfilling the device. If you con-
tinue filling, the interval of the signal is shortened.
If a continuous tone sounds, the bath vessel is full. If you continue
filling the device, it will overflow.
7. If the fill level (starting at level 5) is adequate, press the [Standby]
softkey to start the pump and fill the connected external consuming
unit.
Heat transfer liquid is pumped into the external consuming unit.

The level of the heat transfer liquid in the bath vessel drops.
8. Replenish the heat transfer liquid.
If, however, the fill level drops too far, the device automatically

switches to the "Low level" alarm state. The pump is switched off.
9. Add sufficient heat transfer liquid. Deactivate the alarm using the
[Unlock key]. The pump automatically restarts.
10. Carry out steps 8 and 9 until the device and the connected con-
suming unit are filled.
11. Press [Stop filling] to exit from filling mode and deactivate the
acoustic alerts.
The [filling mode] can be used to refill the device during operation.
If [Fill mode] is active, the device does not heat or cool. You can
only start the device after you end [Fill mode].
PRO bath thermostats and circulation thermostats
If filling mode is active, the [Pump] tile will bear the filling
mode lettering against a yellow background. The device does
not heat or cool.
The quantity per level is approximately 0.15 liters. With a
quantity of 2.4 liters or more in the bath vessel, level 1 is
displayed.
63 / 156