Lauda P 10 Operation Manual page 50

ID Function
104 Contact output 2: 0 = open / 1 = closed
106 Contact output 3: 0 = open / 1 = closed
Table 26: SW version
ID Function
108 Control system
109 Protection system
110 Remote control (Command)
(remote control unit must be present)
111 Cooling system
(only for devices with active cooling)
112 Analog interface module
(interface module must be present)
114 RS 232/485 interface module or Profibus / Profinet
(interface module must be present)
116 EtherCAT interface module
(interface module must be present)
117 Contact interface module
(interface module must be present)
118 Solenoid valve for cooling water
(solenoid valve must be present)
119 Solenoid valve for automatic filling device
(solenoid valve must be present)
120 Solenoid valve for constant level device
(Solenoid valve must be present)
121 Solenoid valve, shut off valve 1
(Solenoid valve must be present)
122 Solenoid valve, shut off valve 2
(Solenoid valve must be present)
128 External Pt100 interface 0
(module must be present)
50 / 156
Note the following instructions:
" " (blank space) can also be used for "_".

If not otherwise specified in the command, the response will always be

given in fixed point format "XXX.XX" or for negative values "-XXX.XX" or
"ERR_X". (RS 485 interface e.g. "A015_XXX.XX" or "A015_ERR_X").
The command from the control station must be made with a CR, CRLF

or LFCR.
PRO bath thermostats and circulation thermostats
Unit Command
[–] IN_DO_02
[–] IN_DO_03
Unit Command
[–] VERSION_R
[–] VERSION_S
[–] VERSION_B
[–] VERSION_T
[–] VERSION_A
[–] VERSION_V
[–] VERSION_Z
[–] VERSION_D
[–] VERSION_M_0
[–] VERSION_M_1
[–] VERSION_M_2
[–] VERSION_M_3
[–] VERSION_M_4
[–] VERSION_E
V6