Lauda P 10 Operation Manual page 45

Table 9: Cooling
ID Function
23 Cooling mode: 0 = Off / 1 = On / 2 = Automatic
Table 10: Safety
ID Function
34 Timeout communication via interface (1 - 99 seconds; 0 = Off)
72 Activate Safety Mode = 1
Safe operating statuses of the device in the event of a fault are
defined in Safety Mode. These operating statuses must be entered
by the user beforehand.
Table 11: Control parameters
ID Function
38 Control parameter Xp
40 Control parameter Tn (5– 180 s; 181 = Off)
42 Control parameter Tv
44 Control parameter Td
46 Control parameter KpE
48 Control parameter TnE (0– 9000 s; 9001 = Off)
50 Control parameter TvE (5 = Off)
52 Control parameter TdE
54 Correction limitation
56 Control parameter XpF
60 Control parameter Prop_E
Table 12: Control
ID Function
58 Set point offset
66 Control in control variable X: 0 = internal / 1 = external Pt / 2 =
external analog / 3 = external serial / 5 = external Ethernet / 6 =
external EtherCAT / 7 = external Pt second (only on Integral)
68 Offset source X for set point: 0 = normal / 1 = external Pt / 2 =
external analog / 3 = external serial / 5 = external Ethernet / 6 =
external EtherCAT / 7 = external Pt second
Comment (ID 66 and 68): If X=3, the commands ID 66 and ID 68 cannot be executed in some constant temperature
control devices until an external temperature specification has been received (via the command ID 15). Also notice that
the command OUT_PV_05_XXX.XX must be cyclically transmitted by the selected interface.
V6 PRO bath thermostats and circulation thermostats
Unit Command
[–] OUT_SP_02_[Value]
Unit Command
[s] OUT_SP_08_[Value]
[–] OUT_MODE_06_1
Unit Command
[–] OUT_PAR_00_XX.X
[s] OUT_PAR_01_XXX
[s] OUT_PAR_02_XXX
[s] OUT_PAR_03_XX.X
[–] OUT_PAR_04_XX.XX
[s] OUT_PAR_05_XXXX
[s] OUT_PAR_06_XXXX
[s] OUT_PAR_07_XXXX.X
[K] OUT_PAR_09_XXX.X
[–] OUT_PAR_10_XX.X
[K] OUT_PAR_15_XXX
Unit Command
[K] OUT_PAR_14_XXX.X
[–] OUT_MODE_01_X
[–] OUT_MODE_04_X
45 / 156