LEGRAND KEOR HPE 60 kVA Operating Manual page 1034

2.3.4 Installation
The product must be installed in strict compliance with the instructions contained in the technical back-
up documentation, including the present safety instructions. In particular, the following points must be
taken into account:
 The product must be placed on a base suitable to carry its weight and to ensure its vertical
position;
 The UPS must be installed in a room with restricted access, according to standard CEI
EN62040-1;
 UPS category: C3 according to IEC 62040-2
 Never install the equipment near liquids or in an excessively damp environment;
 Never let a liquid or foreign body penetrate inside the device;
 Never block the ventilation grates;
 Never expose the device to direct sunlight or place it near a source of heat.
Special environmental conditions
The UPS is designed for normal climatic and environmental operating conditions as defined in
the technical specification: altitude, ambient operating temperature, relative humidity and
environmental transport and storage conditions. It is necessary to implement specific
protective measures in case of unusual conditions:
 harmful smoke, dust, abrasive dust;
 humidity, vapour, salt air, bad weather or dripping;
 explosive dust and gas mixture;
 extreme temperature variations;
 bad ventilation;
 conductive or radiant heat from other sources;
 strong electromagnetic fields;
 radioactive levels higher than those of the natural environment;
 fungus, insects, vermin.
 Conductive dust ie with carbon particles
Use authorized personnel only
All transport, installation and start-up operations must be carried out by qualified and trained
personnel.
The installation of the UPS must be carried out by authorized personnel, in compliance with
national and local regulations.
18 OMW07096 REV. E
Installation and start-up of KEOR HPE UPS 60÷80 kVA
Installation et démarrage de l'ASI KEOR HPE 60÷80 kVA
Installazione e avviamento KEOR HPE UPS 60÷80 kVA