Table of Contents
Advertisement
Fire protection
The excavator components and attachments (in particular the engine and the exhaust system) reach
high temperatures even under normal working conditions. An electric installation that is damaged or
STOP
not properly serviced may lead to flashovers and/or electric arcs. The following fire protection guide-
lines may help you ensure the maintenance and efficiency of your equipment and minimise fire haz-
ards.
Remove any accumulated dirt adjacent to hot components, e.g. engine, muffler, exhaust manifold/tubes, etc.
If the machine is being used at full capacity, cleaning should be performed more frequently.
Accumulated residues from plants and trees, or any other flammable materials, should be removed from the
machine. This must be observed in particular in the proximity of the engine and the exhaust system, but also
in the swivel frame, the track frame, and the boom.
Check the condition and wear of all fuel lines and hydraulic hoses. Any defective parts should be replaced
immediately in order to avoid leaks.
Electric cables and connections must be checked regularly for signs of damage. Damaged components and
lines must be replaced or repaired before starting up the machine. All electric connections must be kept clean
and tight.
Exhaust pipes and mufflers must be checked daily for leaks, damage and any loose or missing joints. Leaking
or damaged exhaust system components must be replaced or repaired before starting up the machine.
Always keep a multi-purpose fire extinguisher on or close to the machine. Familiarise yourself with the oper-
ation of the fire extinguisher. In the event of a fire in the electrical or hydraulic system, use a CO
guisher to put it out.
A fire extinguisher is not included in the standard equipment of the machine.
28
Safety rules
fire extin-
2
W9232-8135-6
12/2015
Advertisement
Table of Contents
Troubleshooting
