Sample Introduction System; Lighting The Plasma - Thermo Scientific iCAP 7000 Series Manual

iCAP 7000 Series ICP-OES Spectrometer

7 Sample Introduction System

Sample Introduction System
Assemble the torch, torch holder, Assemble the torch, torch holder, spray chamber and tubing as detailed in the customer manuals
Clean the spray chamber in a 10% v/v Decon solution (or a suitable laboratory surfactant) for 30 Clean the spray chamber in a 1
minutes (remove the o-rings and replace them after rinsing the spray chamber).
8

Lighting the Plasma

Lighting the Plasma
Connect the PC to the iCAP with the Connect the PC to the iCAP with the
network cable
Use the shortcut on the desktop to Load Use the shortcut on the desktop to Load
Qtegra
Note:- Failure to communicate at this stage indicate Failure to communicate at this stage indicates one of the following problems:
The network card not set to 90.0.0.1, etwork card not set to 90.0.0.1,
The network cable not plugged in correctly. etwork cable not plugged in correctly.
The iCAP Spectrometer does not have
The software was installed with the firewall turned ON (Turn off the F The software was installed with the firewall turned ON (Turn off the Firewalls and reinstall Qtegra)
Click on Dashboard to open configuration to open configuration
choice.
Select "iCAP 7000" Configuration Select "iCAP 7000" Configuration
Page 21 of 36
OES Spectrometer
spray chamber and tubing as detailed in the customer manuals.
0% v/v Decon solution (or a suitable laboratory surfactant) for 30
rings and replace them after rinsing the spray chamber). rings and replace them after rinsing the spray chamber).
255.255.255.0 255.255.255.0
does not have the correct iTEVA 9.9 instrument firmware loaded.
Sample introduction set up Sample introduction set up
s one of the following problems:
Installation Details
□
irmware loaded.
irewalls and reinstall Qtegra)
Version 4301 460 00632 Version 4301 460 00632