Display Board (P/N 06457); Current Sensors (P/N 05109) - Webasto PosiCharge DVS Field Service Manual

DVS/GSE

3.1.4.10 Display Board (P/N 06457)

The Display board is mounted to the door underneath the Control board (Ref. 3.1.4.9). It is held
th
in place by 4 5/16 nuts. A 14 pin connector connects the Display board to the Control board.
To remove:

3.1.4.11 Current Sensors (P/N 05109)

The Current Sensors are mounted on the back wall of the station. They are held in place by 2
phillips head screws. A 2/0 cable runs through the sensors from the inductor to the buss bar
between the contactors. To remove:
09030-78B
GSE
1. Remove the Control board
2. Remove the 4 5/16
to damage the components while
loosening or tightening the nuts)
3. Remove the board
4. Reverse these steps to install the board
1. Remove the 7/16th nut that mounts the
2/0 cable to the buss bar between the
contactors.
2. Remove the 2 phillips head screws
3. Slide the Current Sensor over the lug to
remove
4. Reverse these steps to install the sensor
Webasto Charging Systems, Inc.
30 49
of
DVS
Field Service Manual
th
nuts (Be careful not