Equipment Installation - Flashforge AD1 User Manual

1.Mounting support
1.Lift the equipment to the shelf or table before installation; reserve a corner before
installing the support.
2.Rotate the support clockwise to the bottom. Install the 4 supports in sequence.
3.Shake the equipment by hand to check whether it shakes, and adjust the height of the
supports to make the 3D printer stand smoothly.
2.Install the mounting bracket
1.Remove the four M3 screws and the spring
washers; remove the four M8 flat-head
screws and the spring washers; remove the
parts of the tray bracket and install the left
and right sheet metal brackets onto the
equipment.

1.3 Equipment Installation

12
2.Use an Allen key to attach the left and
right sheet metal brackets to the equipment
with four M8 screws.