Chapter 6: About Software; Software Installation; Exploring Flashprint - Flashforge Creator Pro User Manual

Chapter 6: About Software

This chapter talks about the basic function of FlashPrint. For more information about advanced function,
you can browse our website www.flashforge.com.
IEIIIIII

Software Installation

6.1.1 Software Acquisition
• Method 1: To get the installation package from the SO card.
• Method 2: Open the link below to download the installation package: www.flashforge.com
Steps: Support - Downloads - FlashPrint - Choose Software Version - Download
6.1.2 Software Installation and Start-up
1. Decompress the zipped file and start the installation program, and then install the software
according to the direction.
2. Start the software with the start menu shortcut by left double clicking .

.,_ Exploring FlashPrint

Note: Before updating Firmware, you need to install a relevant drive.
6. 2.1 Machine Type Selection
Attention! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just need to select FlashForge Creator Pro in the
machine type list and click [OK].
You can also change the machine type via clicking [Print] - [Machine type].
� Flash Print - untitle.fpp
Edit Tools
I ])_
File Print View
Print
Machine type
Help
Ctrl+P
►
FlashForge Creator Pro
FlashForge Dreamer
FlashForge Finder
FlashForge Guider
FlashForge Guider II
FlashForge Inventor
FlashForge Inventor II
FlashForge Hunter
60