Flashforge AD1 User Manual page 40

Acrylic sheet assembly
When assembling, put the model in the bottom and the acrylic sheet on the top, align the
edges and corners, press as a whole to avoiding falling and light transmittance, and then
apply glue for reinforcement.
Instructions:
• There are different levels of filament accumulation and deformation at the corners and
bends, especially for models with a large degree of curvature and a tilting effect. You
need to press hard or polish the acrylic, or modify the contour line, as shown in the
figure:
• As mentioned above, the model has overlap, the contour line and the acrylic sheet
have interruption, and need to be assembled separately. The effect is as shown in the
figure, and the interrupted part will not transmit light.
39