Flashforge AD1 User Manual page 5

Equipment Operation Tips
Do not left the running equipment unattended for a long time.
Do not modify the equipment.
Operate the equipment in a ventilated environment.
Do not use this equipment for illegal activities.
Do not use this equipment to make food storage products.
Do not use this equipment to make electrical products.
Do not put the printing model into your mouth.
Do not use brute force to remove the printing model.
Do not connect the equipment with a network cable longer than 3m.
If the equipment is not in use, please remove the supplies in the extruder.
If the equipment is not used for a long time, use a dust cloth to cover it.
When the adhesion of the blue textured paper becomes weaker on the shell, replace
the paper.
Requirements for Equipment Operating Environment
Temperature: 15-30°C
Relative humidity: 20% -70%
Equipment Maintenance
Abnormal noise may occur if the equipment is used for a long time. Please apply
lubricant on the rails and the screw regularly. It is recommended to apply once every
two weeks.
Equipment Placement Requirements
The equipment needs to be placed in a dry, ventilated environment. The left and rear
sides must have a space at least 20cm, the front side must have a space at least 35cm,
and the right side must have a space at least 40cm.
Requirements for Equipment Compatible Supplies
When operating the equipment, only use supplies supplied or specified by Flashforge.
Third-party supplies may cause extruder blockage and damage.
Supplies Storage Requirements
Do not unpack the supplies unless needed. Keep the storage environment dry and free
of dust after unpacking.
04