Flush Mounting - HIKVISION DS-KD9403-E6 User Manual

Video Intercom Face Recognition Door Station User Manual
Note
Do not touch the SD card slot and other devices during the process of plugging
●
in and unplugging the power interface.
Apply Silicone sealant among the joints between the device and the wall
●
(except the lower side) to keep the raindrop from entering.

4.1.3 Flush Mounting

Steps
1. Cave an installation hole in the wall. The suggested dimension of the installation
hole is 237.5 mm (W) × 128.9 mm (H) × 41.3 mm (D). Pull the cables out from the
wall. Insert the gang box into the installation hole, and mark the gang box screw
holes' position with a marker.
2. Take out the gang box. Drill 4 holes according to the marks on the wall, and insert
the expansion sleeves into the screw holes. Fix the gang box with 4 expansion
bolts.
3. Insert the door station into the gang box, and fix it with set screws.
Note
Do not touch the SD card slot and other devices during the process of plugging in
and unplugging the power interface.
Figure 4-3 Surface Mounting
11