Flush Mounting With Gang Box - HIKVISION DS-KD9203 Series User Manual

Video Intercom Face Recognition Door Station User Manual

4.2 Flush Mounting with Gang Box

Steps
1. Cave an installation hole in the wall. Pull the cable out from the wall.
Note
The suggested dimension of the installation hole is 364.3 mm (W) × 118.6 mm (H) × 40.2 mm
●
(D).
The suggested length of the cables left outside is 250 mm.
●
2. Install the gang box into the wall.
1) Remove the plastic sheet of the gang box with the tool.
2) Insert the gang box into the installation hole. Mark the gang box screw holes' position with a
marker, and take out the gang box.
3) Drill 4 holes according to the marks on the wall, and insert the expansion sleeves into the
screw holes.
4) Fix the gang box with 4 expansion bolts.
3. Fix the gap between the gang box and wall with concrete. Remove the mounting ears with tool
after concrete is dry. Connect the cables according to the Wiring Description.
4. Insert the door station into the gang box. Slide the door station down and fix it with 2 set
screws. Apply Silicone sealant among the joints between the device and the wall (except the
lower side) to keep the raindrop from entering.
12