Programming the Devices Using
JTAG
The T2 card is preprogrammed with an image that allows you to use the flash application
(flash_app) to program the QSPI flash memories that are connected to the
Zynq UltraScale+ RFSoC ZU48 device.
The QSPI flash or the devices can also be programmed through JTAG using an ADK connector.
The Xilinx tools must be installed on a computer and then connected to the T2 card through an
ADK connector. An ADK connector is not part of the T2 card and must be obtained separately.
The following figure shows the connection on a T2 card for the ADK ribbon cable.
UG1527 (v1.0) June 15, 2022
T2 Telco Accelerator Card Installation Guide
Chapter 9: Programming the Devices Using JTAG
Send Feedback
Chapter 9
www.xilinx.com
27