AMD XILINX T2 Telco Installation Manual page 29

To complete the setup, connect the ribbon cable to the ADK card, then connect the ADK card to
a micro USB cable so that it can connect to a computer that can run the Xilinx tools. The full
connection is shown below.
UG1527 (v1.0) June 15, 2022
T2 Telco Accelerator Card Installation Guide
Figure 8: Connected ADK Ribbon Cable Backside
Figure 9: T2 Card Connected to ADK
Chapter 9: Programming the Devices Using JTAG
Send Feedback
www.xilinx.com
29