Flashing The Images To Zu48 Zynq Ultrascale+ Rfsoc Qspi Using The Vitis Environment - AMD XILINX T2 Telco Installation Manual

The following figure shows the T2 card installed into a server, with the ADK cable attached and
the micro USB cable going out of the back of the server. This setup allows the USB to be
connected to an external laptop running on the server. The Xilinx tools can be used on the laptop
or the server to program the devices on the T2 card.
Flashing the Images to ZU48
Zynq UltraScale+ RFSoC QSPI Using the Vitis
Environment
Use the same setup as in
connector is attached.
UG1527 (v1.0) June 15, 2022
T2 Telco Accelerator Card Installation Guide
Figure 10: T2 Card with ADK in Server
Chapter 9: Programming the Devices Using JTAG
Chapter 9: Programming the Devices Using JTAG
Send Feedback
to ensure the ADK
www.xilinx.com
30