AMD XILINX T2 Telco Installation Manual page 32

1. Disable the PCIe slot in BIOS settings using the iDRAC GUI.
2. Perform a warm reboot on the host machine.
3. Program the bitstream using Vivado Hardware Manager as shown in the following figure for
the ZU48 device.
4. Enable the PCIe slot in the BIOS settings using the iDRAC GUI.
Note: iDRAC versions are different. After changing the PCIe settings in the slot using the BIOS in the
iDRAC GUI, you might also need to change the PCIe settings in the console during the restart.
5. Perform a warm reboot on the host machine.
UG1527 (v1.0) June 15, 2022
T2 Telco Accelerator Card Installation Guide
Chapter 9: Programming the Devices Using JTAG
Send Feedback
www.xilinx.com
32