Rotate The Transmitter On The Sensor (Optional) - Emerson Micro Motion 5700 Instruction Manual

Mounting and sensor wiring
April 2022
3.5

Rotate the transmitter on the sensor (optional)

In integral installations, you can rotate the transmitter on the sensor up to 360° in 45°
increments.
Procedure
1. Using a 4 mm hex key, loosen and remove the clamp securing the transmitter head
2. Gently lift the transmitter straight up, and rotate the transmitter to the desired
3. Gently lower the transmitter onto the base, confirming that the transmitter is in a
20
in place.
Figure 3-12: Removal of the sensor clamp
position.
You can rotate the transmitter to any of the eight positions, but a stop exists that
will not allow a full 360° rotation.
Figure 3-13: Rotate transmitter head
locked position.
Micro Motion 5700 Transmitters with Configurable Inputs and Outputs
Installation Manual
MMI-20027478