Table of Contents
Advertisement
Installation Manual
00825-0100-1600
3.3
Rotate the transmitter on the sensor (optional)
In integral installations, you can rotate the transmitter on the sensor up to 360º in 45º
increments.
Procedure
1. Using a 4 mm hex key, loosen and remove the clamp securing the transmitter head
2. Gently lift the transmitter straight up, and rotate the transmitter to the desired
3. Gently lower the transmitter onto the base, confirming that the transmitter is in a
4. Replace the clamp in its original position and tighten the cap screw. Torque to 29 in
3.4
Rotate the transmitter display
Configure the software to rotate the transmitter display 0°, 90°, 180°, or 270°. You cannot
physically rotate the display.
Procedure
1. Choose Menu → Configuration → Display Settings → Rotation.
2. Select the appropriate direction.
Installation Manual
in place.
Figure 3-3: Removal of the sensor clamp
position.
You can rotate the transmitter to any of the eight positions, but a stop exists that
will not allow a full 360° rotation.
locked position.
lbf (3.28 N m) to 31 in lbf (3.50 N m).
Mounting and sensor wiring
March 2022
15
Advertisement
Table of Contents
