2/ System Specifications; Component Main Data; Table 2: Component Main Data - Kontron COMe Eval Carrier T7 User Manual

2/ System specifications

2.1. Component Main Data

The table below summarizes the features of the motherboard.

Table 2: Component Main Data

COMe Eval Carrier T7 (A2T7)
Form factor Testing Hardware with 244.0 mm x 305.0 mm
Memory
EEPROM System
PICMG EEPROM
(U17)
I/O
LAN 1x RJ45 GbE port, expansion slot for 4x 10 GbE adapter cards
USB 4x USB 3.1 double stack
COM
2x DSUB-9
SATA 2x standard slots
Feature Connector Various control signals - such as WAKE, THRM, SMB, I2C
PCIe 1x x16, 1x x8, 2x x4, supporting up to PCIe Gen4
LEDs SMD LEDs e.g. for carrier activity, board status, LAN and power status (power good)
GPIO GPIO Header for 8 GPIO signals
SMBus header 5-pin header
I2C 4-pin header
Battery
CR2032 battery holder
Fan 4-pin fan connector, Voltage can be 5 V or 12 V (default)
NC-SI 24-pin Network controller sideband interface
Carrier Board Power
Power input Carrier is powered from standard ATX power supply with ATX 24-pin connector.
Single Supply carrier requires ATX power
Support
ACPI ACPI 4.0
S-States S0, S4, S5
Single Supply
yes
Simulation Mode
Misc Power yes
Management
Kontron Features
External I2C Bus Fast I2C, MultiMaster capable
M.A.R.S. support no
Danger of explosion if the lithium battery is incorrectly replaced.
www.kontron.com
• Replace only with the same or equivalent type recommended by the manufacturer
• Dispose of used batteries according to the manufacturer's instructions
COMe Eval Carrier T7 (A2T7) User Guide Rev 1.1
// 17