Skp16C62P Board Jumper Configuration; Jp1: Mcu (U1) Power; Jp2: Xout; Lcd (Liquid Crystal Display) - Renesas SKP16C62P User Manual

Table of Contents

5.4 SKP16C62P Board Jumper Configuration

JP1 is used to connect the power/Vcc pins of the M16C/62P MCU to the Vcc of the board. It can

be used to measure current/power consumption of the MCU during various modes of operation.

For normal operations, JP1 must be shorted.

JP1 is shorted by default.

JP2 is used to connect the output of the MCU's internal amplifier to the crystal for oscillation. It

can be used to disconnect Xout when an externally driven clock is connected to Xin. For normal

operations, JP2 must be shorted.

JP2 is shorted by default.

5.4.3

Default Jumper Setting

Jumper

Setting

The LCD is a 2-line by 8-character display with a KS0066 controller IC.

SKP16C62P User's Manual Rev. 1.0

Downloaded from

Elcodis.com

electronic components distributor

JP1

JP2

MCU Power

Xout

Shorted

9 / 22

Applications Engineering

December 2003

Table of Contents