Diagnosis; Vehicle Connection - Xtool H6 Elite Smart User Manual

4. D
IAGNOSIS
The diagnostic application can read ECU information, read and clear DTC
and check living data and freeze frames. The diagnosis application can
access the electronic control unit (ECU) of various vehicle control systems,
including the engine, transmission, anti-lock braking system (ABS), airbag
system (SRS), and perform kinds of actuation tests.
4.1.

VEHICLE CONNECTION

The diagnosis operation needs to connect the H6 Elite Smart Diagnostics
System to a vehicle first so that the tablet can establish correct vehicle
communication. Please perform the following steps:
Since the display tablet and the VCI box are integrated, to communicate with
the vehicle, the OBDⅡ-16 connector must be connected to the main test
cable, and the vehicle data connector should be inserted into the DLC
usually located under the vehicle dashboard. The OBDII-16 adapter should
be connected to the vehicle, the main test line should be connected to the
OBDII-16 adapter, and the tablet
The connection method is shown in the figure below:
Please perform the following steps:
Turn on the tablet;
Connect cables and tablet in the following order: ①→②→③→④;
Switch on the ignition and tap on the Diagnosis application to test vehicles.
The connection method is shown in the figure below:
19