4.2.5
After installation
Assign slot numbers
After installation you can assign a slot number to each module, and this makes it easier to
assign the modules to the configuration table in STEP 7 or in COM PROFIBUS. The following
table illustrates the assignment of the slots.
Table 4- 4
Slot number
The use of the power supply is optional.
1
Unoccupied slots
If, in a configuration of an ET 200M with active bus modules, slots are unoccupied (e.g.
reserved for later use), then you must leave these slots free in the configuration in STEP 7 or
COM PROFIBUS!
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
Slot numbers for S7 modules
Module
1
2
3
4
5
...
11
Power supply (PS)
1
IM 153-x
–
1. S7-300 module
2. S7-300 module
...
8. S7-300 module
Installation
4.2 Installation
Remark
–
–
inapplicable
right alongside the IM 153-x
–
–
–
67