Fdr Base" Window; Manual Operation - Yamaha SIGMA-G5SII Service Information

2.6.6. "FDR BASE" Window

Note:
This window is used to check the feeder connection condition.

2.7. Manual Operation

(1) The confirmation for the single unit operation in each section or the confirmation of the
measurement for the teaching, after machine maintenance, is performed using the
manual operation and manual axis operation.
This operation is performed on the tab sheet under the "Maint." menu item. For the
manual operation, the operation in debug mode is partly required.
Refer to "2.9 Change Procedure to Debug Mode" for the transferring procedure to
debug mode.
The manual operation and manual axis operation are divided into the following two
items.
[1] Unit Adjustment : This operation used for the unit operation, includes the nozzle
[2] Device Check : This operation is used for checking of operation in each section
Service Information
change, linear measure detection test, cutter operation,
conveyor width change, etc.
* The nozzle change procedure and conveyor width change
procedure are described in the other section.
using the "Output Check" window and dimension
measurements such as height, using the manual axis operation.
SI1705004E-00=SIGMA-G5SII Service Manual
74/273
For Service Engineer