Yamaha SIGMA-G5SII Service Information page 68

The PCB manual transfer procedure to the operator's desired location, is described as
follows.
(1) Place a PCB on the input conveyor.
(2) Open the PCB Transfer window.
(3) Select " MNL XFER " .
(4) Select one of the "XFER Start" arrows. Then, within 5 seconds, pressing the [START]
button transfers the PCB. Each pressing moves the PCB a certain distance in the
designated direction.
Service Information
SI1705004E-00=SIGMA-G5SII Service Manual
68/273
For Service Engineer