Cutter Unit Attachment To The Feeder Cart - Yamaha SIGMA-G5SII Service Information

(4) Slide the unit slightly to this side (about 20 cm).
There are communication and power cables on the right hand side of the unit.
Disconnect them and make the unit free.
Draw the unit slightly out to this side.
(5) After making the unit free, slide it further to this side.
A screw has been attached around the outlet. Close to that location, lift the cutter unit
as much as the thickness of the screw head.
Note:
When the cutter unit is to be removed, because it is very heavy, remove it taking care not to drop it on
your foot.
* The weight of the unit is about 20kg. When it is removed, take the greatest care.

4.14.2. Cutter Unit Attachment to the Feeder Cart

Attach the cutter unit onto the feeder cart using the reverse procedure of Item 4.14.1.
* After the cable connection, take care not to catch the cable when the unit is pressed
against the machine.
Bolts on the right and left (two locations)
Fig.D95
Service Information
Disconnect the three connectors.
Fig.D94
Slide the unit to this side and remove.
SI1705004E-00=SIGMA-G5SII Service Manual
173/273
For Service Engineer