SRAM RockShox Super Deluxe Coil Service Manual page 30

31 Thread the bottom post onto the damper shaft and tighten to
8 N·m (75 in-lbs).
32
Install the check piston assembly onto the damper shaft. Align the shim
stack on top of the main piston.
Note: the cutouts on the check plate must face the main piston for
the Hydraulic Bottom Out feature to function properly.
Keep the piston assembly parts in the order they were removed. Do
not separate any parts from the piston assembly.
If any piston assembly parts are installed in the incorrect order,
the piston assembly, including the tune shim stacks, must be
reassembled in the correct order for proper shock function. Refer
to the Rear Suspension Shim Tuning Guide for piston assembly and
shim stack configurations.
33 Thread the check piston nut onto the damper shaft and tighten to
2 N·m (75 in-lbs).
34 Remove the damper shaft assembly from the vise.
NOTI CE
Check plate cutout
12 mm 8 N·m (75 in-lbs)
8 mm 2 N·m (75 in-lbs)
30
Damper and IFP Service