SRAM RockShox Super Deluxe Coil Service Manual page 32

4 Remove the IFP o-ring and clean the IFP.
Apply grease to the new o-ring and install it onto the IFP.
5
Install the IFP into the damper body with the inset side visible. Use a
metric caliper or ruler to push the IFP into the reservoir to a depth
of 20 mm.
Tap the top of the damper body a few more times to push any trapped
air through the IFP bleed port. When no more air bubbles emerge from
the bleed port, immediately cover the damper body with your hand.
6 Continue to cover the damper body with your hand and install a new
bleed screw into the bleed port. Tighten the bleed screw until the IFP
begins to spin.
A small amount of grease on the tip of the TORX wrench will keep the
bleed screw in place while installing it.
Remove your hand from the damper body.
7 Pour additional oil into the damper body until the oil is level with the
top of the threads.
RockShox Dynamic Seal Grease
7wt
20 mm
T10
Maxima PLUSH Suspension Oil
32
IFP Reservoir Service