Table of Contents
Advertisement
13
Clamp the shaft eyelet into the vise.
14
Remove the check piston nut.
15
Slide the two upper shims, the check piston, and the two lower shims
off the shaft and onto a small hex wrench or pick.
Keep the piston assembly parts in the order they were removed. Do
no separate any parts from the piston assembly.
If any piston assembly parts are installed in the incorrect order,
the piston assembly, including the tune shim stacks, must be
reassembled in the correct order for proper shock function. Refer
to the Rear Suspension Shim Tuning Guide for piston assembly and
shim stack configurations.
NOTI CE
8 mm
Top of shim stack
Bottom of shim stack
25
Damper and IFP Service
Advertisement
Table of Contents
